FAQ&Troubleshooting Manual of Vertical Roller MillPosted: 2016-09-27

  • As we know the mian characters of vertical roller mill is the long continuous working, and widely output size range. There we list several troubleshootings during the vertical roller mill working to help the user can fix them shortly. 

    vertical roller mill

    The above is the picture of vertical roller mill. now let's see the FAQ&Troubleshooting Manual of it.

     

     

     

     

     

     

     

     

     

     

     

     

     

     

     

     

     

    Main unit

     

     

     

    The temperature of bearing is too high

    1. Overloaded

    2. Main unit, classifier bearings are not well lubricated.

    3. The deflection of rollers, vibration, and abnormal sound occurred.

    4. Bearing installation error

    1. Reduce feeding amount, keep the input and output be balanced against each other.

    2.  Fill oil timely.

    3. Open the machine to check if rollers and shafts are seriously worn out; replace spare parts according to the situation.

    4. Re-install main unit, adjust the bearing gap to ensure proper bearing load.

     

     

     

    Processing materials fall out

    1. Overfeeding.

    2. Input and output quantities are not balanced.

    3.  Blower current is too low

    1. Reduce feeding amount

    2. Adjust feeding and classifier, stabilize the current of the blower, balance input and output of processing materials.

    3. Check if the pressure of compressor air system is too low, or check if pulse valves stopped working.

    4. Check if filter bags stuck, if yes, please clean the filter bags and replace them.

     

     

     

    Severe vibration of main unit

    1. Foundation not flat; foundation bolts loose.

    2. Connection bolts loose

    3. Ring and rollers are badly distorted.

    4. Processing materials are very hard, no lining.

    5. Feeding size is too big.

    1. Make foundation flat, Fasten the loose bolts.

    2. Fasten the loose bolts.

    3. Replace ring and rollers

    4. Reduce feeding size of processing materials.

    5. Adjust crusher, makes feeding materials smaller.

     

     

    Nylon stick broken frequently

    1. Foundation bolts of motor or reducer loose

    2. The reducer shaft pops up and down

     

    1. Correct the coupling concentricity and keep paralleled, fasten the loose bolts.

    2. The bearing is worn, replace the bearing, and adjust the gap between wheel gears.

     

    Abnormal sound inside the grinding chamber

    1. Crushing components loose

    2. Hard materials enter into grinding chamber (such as parts, super hard impurities).

    1. Shut down the machine and fasten loose components.

    2. Shut down the machine and find out reasons; take out super hard impurities and take preventive measures.

     

     

     

     

Previous:Production Factors of Jaw Crusher
Next:Iron Oxide Grinding Mill

Feedback

Recommend

Ultrafine Grinding Mill

Capacity:0.5-30 t/h
Feeding size:≤20mm
Output Size:5-74um/mesh
Info:HGM Series ultrafine grinding mill is the equipment specializing in producing fine and superfine powder of non-inflammable...

    Contact us

  • Office Address: No.19Fuqing Rd,Shanghai
  • E-mail: Sales@clirik.com
  • Sales Department Tel 0086-21-20236178

Copyright 2014 by Shanghai Clirik Machinery Co. LTD All rights reservedE-mail:sales@clirik.com